Mike’s Pot Roast

Mike’s Pot Roast

Ingredients

  • 3 to 3 1/2 lb boneless chuck roast,  well marbled
  • 2 T extra virgin olive oil
  • 2 T butter
  • 1 large Sweet onion, chopped
  • 2 cloves of garlic, minced
  • 3 stalks celery, diced
  • 3 carrots, peeled and diced
  • 3 carrots, peeled and cut into large chunks
  • 1/4 lb Porcini mushrooms, rinsed and sliced
  • 1/2 C Sweet Marsala wine
  • Pinch dried thyme
  • 2-3 T organic tomato paste
  • 1 C low sodium beef broth
  • Salt and pepper

Method

  1. Use a cast iron enamel covered pot  large enough to hold roast and vegetables. Heat 2 T of oil and 1 T butter on medium high heat.  Sprinkle and rub roast with salt and  pepper. Brown roast in pot, several minutes on each side.
  2. When roast is browned, remove from the pot and set on a plate.  Drain all but 1 T of the fat from the pot.  Add the onions, diced carrots, and celery to the pot and cook for about 5 to 10 minutes, until the vegetables start to brown.  Add the garlic, Porcini mushrooms and a pinch of thyme, and saute for another minute.  Add the Marsala wine and continue to saute until the alcohol evaporates.   Add tomato paste, beef broth and mix thoroughly.   Create a “well” in the center by pushing all of the vegetables to the sides of the pot.
  3. Place  the roast in the well you’ve created. (It’s OK if a few veggies are underneath the roast)  Sprinkle another pinch of thyme over the roast. Add extra broth if required to bring the liquid level up to the top of the roast.  Cover and adjust the heat down to a low simmer.
  4. Cook for 2 hours, or longer.
  5. Approximately 45 minutes before serving, remove the roast from the pot and set on a plate.  Allow to cool slightly, about 10 minutes.
  6. Increase heat to medium high and  reduce the gravy to one half its volume.  Add 1 T butter and the carrot chunks.  Reduce heat back to low.
  7. Trim all visible fat and gristle from the roast.  Slice the roast against the grain and return to the pot.  Stir to coat the roast slices thoroughly.
  8. Simmer on low heat for another 30 minutes.

Yield: Serves 4-5.

I have no memories of pot roast from my childhood.  I’m pretty certain we never had pot roast growing up.  Dad did all of the cooking for the family and if you ever tasted my Mom’s cooking you would understand why.  So for me pot roast was  and still is a special dish to be savored.  And this past week, I’ve been thinking about pot roast a lot.  It’s not a hard dish to make and everyone makes it differently.  I kind of made this recipe up and thankfully it worked.

I say thankfully because we were serving this pot roast to friends.  As things turned out, the pot roast turned out.  Mike had seconds.  Mike also won at cards.  So I’ve named this pot roast after Mike.

Tips – Find a nice chuck roast that has a lot of marbling.  This adds tremendous flavor and remember, you’ll be trimming the fat off before serving.  Remember the gravy makes this dish.  I found the addition of Porcini mushrooms to be quite a difference maker. MASHED POTATOES.  You need mashed potatoes, period.  Since we’ve added extra carrots, try a green salad on the side.  And bread.  Some good bread to sop up the gravy is also essential.  One of these times when I have leftover pot roast, I’ll post my Next Day Pot Roast Sandwich.  Sorry, no picture…we ate it all.

More Tips – I have also used a cut of beef called Cross Rib Roast and the results were superb.  Don’t confuse this cut with prime rib or rib roast.  The two are different.  The Cross Rib Roast is basically a different chuck cut.  It is leaner than a chuck roast and possesses a rich, deep beefy flavor.  I also started the dish on the stove top then put the enamel pot covered into a 250 degree oven for three hours.  The roast was fork tender, no knifes needed.

 

Even More Tips – One day I could not find a decent looking piece of chuck for pot roast.  Every roast I saw didn’t have enough marbling.  I did find some well marbled top blade steaks.top blade steaks.  If you’ve ever been out and had a flat iron steak, you have eaten this cut.  But since I bought top blade and not the flat iron cut, it was perfect for this recipe.

Advertisements